KYOWA WGA-910A Series Instruction Manual page 116

7-4-2. Auto Mode, Normal Mode
[X-axis setting: 0.5 sec, 1.0 sec, 2.0 sec]
<Conditions>
Measuring condition setting
Waveform display setting
NOTE
・You can obtain the typical values with the blank recommended SD card (refer to page 28).
・According to the followings, typical values of the T2, T5 and T7 may change with the above values.
Manufactures and types of the SD card
Speed class and capacities of the SD card
Data in the SD card
Operation modes (Block Peak-Bottom, etc.)
・When X-axis setting is 0.5 sec, 1.0 sec, and 2.0 sec, measurement data during switching between screens
(T4, T5) can't be display and record. (Writing of data to SD card take a priority)
Operation mode: Normal
X-axis setting: 2.0 sec, Start Mode of Wave: Auto Mode, Normal Mode
112