KYOWA WGA-910A Series Instruction Manual page 115

7-4. DISPLAYING WAVEFORMS AND OUTPUTTING SD SIGNAL WITH WAVEFORM COMMAND
(CONTROL OUTPUT) AND RECORD KEY
7-4-1. Single Mode
<Conditions>
Measuring condition setting
Waveform display setting
NOTE
・You can obtain the typical values with the blank recommended SD card (refer to page 28).
・According to the followings, typical values of the T3 and T5 may change with the above values.
Manufactures and types of the SD card
Speed class and capacities of the SD card
Data in the SD card
Operation modes (Block Peak-Bottom, etc.)
MEMO
・If you want to cancel the loading of waveform data during loading of waveform data, turn ON and OFF
the Waveform command again.
Operation mode: Normal
X-axis setting: 2.0 sec, Start Mode of Wave: Single mode
111