KYOWA WGA-910A Series Instruction Manual page 135

8-4. OPERATION AND FUNCTION OF THE COM. SETTING (COMMUNICATION SETTING)
(1) Communication Speed
Sets the communication speed (baud rate) of the RS-232C and RS-485.
<Setting Range>
2400, 4800, 9600, 19200 (bps)
<How to operate>
1) Press the
2) Press the
3) Press the
4) Press the
5) Press the
6) Press the target key and
key on the "Measuring" window.
key on the "Setting (1/2)" window.
key on the "Setting (2/2)" window.
key on the "Option Setting" window.
key on the "Com. Setting" window.
key to register the target value.
131
Switch Hold Zero
LL LO OK HI HH
Detecting Measure 1
Holding Block Peak-Bottom
kN
HH 999.99 HI 500.00
LO - 150.00 LL - 999.99
Setting
Calibration is conducted with
Calibration
sensor by 'Manual Input','TEDS
Auto'or'TEDS Part'Cal.
'Smoothing','Additional Value'
Input Setting
and 'Zero Compensation'are set
The sensor output is monitored
'Comparison'and 'Measure Mode'
Meas.Cond.Setting
setting are set as measure-
ment condition.
The necessary setting to dis-
Wave Display Setting
play the wave such as 'X-axis'
and 'Y-axis'are set.
Next
Setting
'Meas.Select Signal'
Initial Setting
'System', 'Self/Operation
Check'and 'SD Card'
'Communication', 'BCD Output',
Option Setting
'DA Output'and 'CC-Link'
are set.
Previous
Option Setting
Return
'Communication Speed','Trans-
Com.Setting
mission Mode'and 'Device ID'
of RS-232C/485 are set.
'Transmission Speed',logic of
BCD Output Setting
each output,and 'BCD Classifi-
cation are set.
'Zero Dsp.'(0V) or 'Full Dsp.'
D/A Output Setting
(10V),and 'D/A Classifica-
tion' are set.
'The Number of Occupied
CC-Link Setting
Stations','Transmission Speed'
and 'Station Number' are set.
Com.Setting
Return
The communication speed of RS-
Communication Speed
232C and RS-485 is set.
9600bps
The transmission mode of com-
Transmission Mode
munication such as the oper-
ation by command is set.
Repeat.Output
It is only applied to RS-485.
Device ID
The ID of WGA-910A is set.
1
Communication Speed
Return
Now
19200bps
New
9600bps
2400bps 4800bps
9600bps 19200bps
Push the target key and 'Register'key.
Set
Measure
1 / 2
Measure
2 / 2
Measure
Measure
Measure
Register