KYOWA WGA-910A Series Instruction Manual page 78

6-3-4-7. Block Peak-Bottom and Time Peak-Bottom
1) Block Peak-Bottom/Normal display mode
"Detect Time", "Delay Time", "Comparison Mode", "Display Mode" can be set. However, the "Detect Time" cannot be set.
(A)Behavior with control input signal
When the HOLD command is turned ON
and after the lapse of delay time, the peak
value and bottom value are detected and
indicated until the HOLD command is
turned OFF.
When the hold command is turned OFF, the
peak value and bottom value are kept hold.
When the RESET command is turned ON,
the hold mode is canceled.
(B) Behavior with key operation
When the
time and after the lapse of the delay time, the
peak value and bottom value are detected
and displayed.
Press the key for the second time to
hold the displayed value.
Press the key for the third time to
cancel the holding value.
(2) Time Peak-Bottom/Hold display mode
"Detect Time", "Delay Time", "Comparison Mode", and "Display Mode" can be set.
(A) Behavior with control input signal
When the HOLD command is turned ON
and after the lapse of delay time, the peak
value and bottom value are detected.
However, during the delay time and
detecting block, the measured value that is
detected immediately after turning ON the
Hold command is displayed.
After the lapse of preset detecting time,
the indicated peak value and bottom value
are kept hold.
When the RESET command is turned ON,
the hold mode is canceled.
(B) Behavior with key operation
Press the key for the first time to
hold the display value at the time.
Though you cannot see, the WGA-910A is
detecting the peak and bottom values after
the lapse of the delay time.
Press the key for the second time to
hold the peak value and bottom value.
Press the key for the third time to
cancel the holding value.
key is pressed for the first
74