KYOWA WGA-910A Series Instruction Manual page 24

3-2. INSTALLATION ONTO A PANEL
To install the WGA-910A to a panel, prepare the panel according to the
specified panel cut dimensions shown at the right.
Then, install the WGA-910A by referring to the following instructions.
1) Cut out the panel according to the panel cut dimensions.
2) Remove screws of the fitting metals attached on both sides of the
WGA-910A and then, pull out the fitting metals.
3) Set the WGA-910A into the cut out panel frame.
4) Set the fitting metals on both sides of the WGA-910A.
5) Tighten the screws and firmly fix the WGA-910A into the panel.
20