Connect An Analog Station Or 2-Wire Digital Station - Avaya G700 Installation And Upgrades

7 Connecting Telephones and Adjunct Systems:
Connect an Analog Station or 2-Wire Digital
Station
This example is typical of the 2-wire digital stations (2420, 64xx, 302D), 2-wire analog stations (2500),
analog Central Office (CO) trunks, Direct Inward Dial (DID) trunks, and external alarms.
1 . Choose a peripheral to connect (such as a 2-wire digital station).
2 . Choose the Media Module to use and its Media Gateway and slot number; for example, MM711
Analog Media Module, Media Gateway 002, Slot V2.
3 . Choose a port circuit on the MM711 Media Module; for example, port 03.
4 . Install cross-connect jumpers to connect the pins from the 2-wire digital station to the
appropriate pins on the MM711 Media Module.
stations.
Table 15. Two-Wire Station Pinout Chart .
Jack Name
BRI-T
ADJUNCT
DSS
(QUEST)
DSS (ISDN)
BRI-A
BRI-U
DCP
ANALOG
HANDSET
5 . Administer using Administrator's Guide for Avaya MultiVantage Software.
Figure 7. 2500-Type Analog Telephone Wiring
Figure notes
1 2500-Type Analog Station
240
1 2 3
+TX
+Vadj T0 -V
DTX DRX
GND
TX1 TX2 RX1
-TX
T 2
R 3
Installation and Upgrades for the G700 with an S8300/S8700
Installation and Wiring Telephones and Power Supplies
Table 15 shows a pinout chart for two-wire
4 5
+RX -RX
GNDVoice RRVoice +V
TX RX
TX RX
TIP RING
+RX -RX
28 T.3
03 R.3
2500wire RBP 071996
2 MM711 Analog Media Module,
Position 1V301
555-234-100 — Issue 2 — October 2002
6 7 8
-TX -V GND
S0 TTVoice
OKdig -V +V
-V
-V GND
RX2 -V +V
+TX