Insert An Avaya X330Stk Stacking Module - Avaya G700 Installation And Upgrades

2 Installing Hardware for the G700 Media Gateway and S8300 Media Server:
Stacking Module

Insert an Avaya X330STK Stacking Module

G700 Media Gateways can be mounted in equipment stacks with routers, switches, or other G700s. The
stack is limited to ten elements. To link multiple units, each G700 must be equipped with an Avaya
X330STK Stacking Module, which is mounted through the rear panel (back view) of the G700.
!
CAUTION:
The Stacking Sub-Module is not hot-swappable. That is, the G700 must be powered off
before you insert or remove a Stacking Module. If there is an S8300 present that is also
turned on, the S8300 should be shut down first, by pressing the Shutdown button until the
OK to Remove LED pn the front faceplate of the S8300 shows a steady green light. Then,
the G700 should be powered off.
Insert an Avaya X330STK Stacking Module
Begin
Remove the blank plate from the back of the G700.
1.
2. Insert the Avaya X330STK Stacking Module gently in the bay in the back of the G700, ensuring
that the metal base plate is aligned with the guide rails.
Figure 12. Insert Stacking Module in G700 (back view)
3. Press the Avaya X330STK Stacking Module in firmly until the connector at the back of the
module is completely inserted into the internal connector on the G700.
4. Tighten the screws on either side of the module.
End
At this point, the required modules and cabling units have been inserted into the G700 Media Gateway. The
next step will be to install cabling.
54
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002
Insert an Avaya X330STK