Avaya G700 Installation And Upgrades page 164

4 Configuring a New G700 with an S8700 (No Local Survivable Processor):
Install New Firmware on the P330 Stack Processor (Layer 2 Switching Processor)
Begin
If the TFTP Server software and G700 firmware files reside on a PC already connected to the
1.
customer's LAN, get the IP address of this PC from the customer.
If necessary, connect an Ethernet cable to one of the two 10/100Base-T Ethernet interfaces in the
2.
bottom center of the G700 chassis. Either port EXT 1 or EXT 2 can be used.
Connect the other end of the Ethernet cable to an Ethernet Layer 2 switch to connect the G700 and
3.
its media modules to the corporate network. LAN topology varies per location.
On your laptop, return to the HyperTerm window. At the MG-mmm-n(config)# prompt, type
4.
exit and press
The P330-1(configure)# prompt appears.
Note: If necessary, open the HyperTerm window, and login to the P330 Stack Processor
command line interface.
At the P330-1(configure)# prompt, type
5.
copy tftp SW_image<file> EW_archive <ew_file>
<tftp_server_address> <Module#>
where
<file> is the image file with format and vintage number similar to viisa3_8_2.exe,
<ew_file> is an embedded web application file with format similar to p330Tweb.3.8.6.exe,
<tftp_server_ip_address> is the ip address of the laptop or PC with the TFTP server, and
<Module#> is the number, 1 through 10, of the media gateway in the stack. If there is only one
G700 Media Gateway, the number is 1.
Verify that the download was successful when the prompt returns. Type show image
6.
version.
Type reset <module#>
7.
The P330 Stack Processor resets. The LEDs flash and self-tests run.
End
Install New Firmware Files on the G700 Media Gateway Processor
Begin
At the P330-1(configure)# prompt, type session mgp to reach the G700 Media Gateway
1.
processor.
Type configure at the MG-???-1(super)# prompt to enter configuration mode, which will
2.
change the prompt to MG-???-1(configure)#.
At the MG-???-1(configure)# prompt, type show mgp bootimage to determine which
3.
disk partition (bank) is Active Now. You will update the bank that is not listed as Active Now. For
example, if the G700 vintage listed when you performed
Install on the G700" on page 151
164
.
E NT ER
showed A, you will upgrade B.
Installation and Upgrades for the G700 with an S8300/S8700
"Determine Necessary Firmware to
555-234-100 — Issue 2 — October 2002