Avaya G700 Installation And Upgrades page 168

4 Configuring a New G700 with an S8700 (No Local Survivable Processor):
6. Type show mgc to display the list of available servers and their IP addresses.
For example:
Figure 71. Show Call Controller Status Screen
MG-001-1(configure)# show mgc
CALL CONTROLLER STATUS
------------------------------------------
Registered
Active Controller
H248 Link Status
H248 Link Error Code: 0x0
MGC List Management : Static
CONFIGURED MGC HOST
--------------------
135.9.71.95
- Not Available --
- Not Available --
- Not Available --
The Gateway will have registered with the S8700, if present. If the S8700 is running and has been
administered properly, the Registered field says YES and the H248 Link Status says UP. If the
server is not running, the Registered field says NO and the H248 Link Status says DOWN.
End
Configure Other G700 Media Gateways (Stack Configuration)
Begin
If the customer has multiple G700 media gateways connected in an IP stack, you can stay
connected to the P330 console port of the master G700/P330 and "session" over from the master
P330 stack processor to the next G700 in the stack. You should have plugged your laptop into the
stack master P330, which you can identify by the LED panel on the upper left of each G700 or
P330 device in the stack as follows:
- On the G700 Media Gateway: a lit MSTR LED indicates that this unit is the stack master.
- On the P330 device: a lit SYS LED indicates that this unit is the stack master.
The G700 and P330 at the bottom of the stack is module number 1, the next module up is number
2,. and so on. However, the stack master can be any module in the stack, depending on the actual
model, the vintage firmware it runs, and whether the S8300 is inserted into it.
168
: YES
: 135.9.71.95
: UP
DHCP SPECIFIED MGC HOST
-----------------------
-- Not Available --
-- Not Available --
-- Not Available --
-- Not Available --
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002