Avaya G700 Installation And Upgrades page 91

3 Configuring a New G700 with an S8300 (Primary Controller or Local Survivable Processor):
Install MultiVantage Patch Files from Your Laptop
Begin
1. From your laptop, start a telnet session to the S8300. (See the final steps in
Software" on page
At the telnet prompt, type cd /var/home/ftp and press
2.
The directory path changes to /var/home/ftp.
At the prompt, type ls -ltr and press
3.
The S8300 displays a list of files in the FTP directory.
Verify that the directory contains the MuliVantage software .tar.gz file you just uploaded.
4.
Type patch_show and press
5.
installed.
The S8300 displays a list of software files currently installed, if any.
!
CAUTION:
Do not remove any of the files in the list.
Type sudo patch_install <patch>.tar.gz, where <patch> is the release or issue number of
6.
the latest software file. Press
Type patch_show again and press
7.
software file was installed.
Type sudo patch_apply <patch>, where <patch> is the release or issue number of the latest
8.
software file. Press
Note: Do not use the .tar.gz extension on the back of the file name.
The S8300 goes through a software reset system 4. The S8300 also may display the message
/opt/ecs/sbin/drestart 1 4 command failed. Ignore this message. You must wait until the
restart/reset has completed before entering additional commands.
The S8300 displays a message that the patch was applied.
Type patch_show again and press
9.
software file was applied.
End
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002
85.)
EN TE R
to list MultiVantage software files that were previously
E NTE R
.
EN TE R
EN TER
EN TER .
EN TER
to access the FTP directory.
E NTE R
to list files in the FTP directory.
to list MultiVantage software files to verify the new
to list MultiVantage software files to verify the new
"Install New
91