Avaya G700 Installation And Upgrades page 192

5 Upgrading an Existing G700 with an S8300 (Primary Controller or Local Survivable Processor):
7. Enter your terminal type. Accept the default value, or enter the appropriate type for your
computer. For example, you may use type ntt, a terminal type available for Windows NT4.0 or
Windows 98. For Windows 2000, use w2ktt.
If prompted for a high-priority session, typically answer n .
8.
The telnet prompt appears. It may take the form <username@devicename>.
If Necessary, Remove old license and authentication files from S8300 FTP Directory
Begin
At the Linux command line, type cd /var/home/ftp and press
1.
The ftp directory path appears.
Type ls -l and press
2.
A list of files appears.
Check the list of files to see if any files with .lic or .pwd suffixes are in the directory.
3.
If any .lic or .pwd files exist, type rm *.lic or rm *.pwd and press
4.
The system removes the files.
Leave the telnet session open for a later task,
5.
S8300 is an LSP)" on page
Log in to the MultiVantage SAT Screens
Begin
If you already have a valid telnet session in progress, access the SAT program by typing sat or
1.
dsat .
Log in to the MultiVantage Software as craft .
2.
Enter your login confirmation information as prompted:
- Password prompt. Type your password in the Password field, and click Login or press Enter
again.
- ASG challenge. If the login is Access Security Gateway (ASG) protected, you will see a
challenge screen. Enter the correct response and click Login or press Enter.
Enter your terminal type. Accept the default value, or enter the appropriate type for your
3.
computer. For example, you may use type ntt, a terminal type available for Windows NT4.0 or
Windows 98. For Windows 2000, use w2ktt.
The SAT interface appears.
4. Enter SAT commands as appropriate.
192
E NT ER .
"Shutdown MultiVantage Software (Only When the
215.
Installation and Upgrades for the G700 with an S8300/S8700
EN TER .
EN TER
555-234-100 — Issue 2 — October 2002
.