Avaya G700 Installation And Upgrades page 176

4 Configuring a New G700 with an S8700 (No Local Survivable Processor):
Add Media Gateways
Begin
When you are logged in to MultiVantage via SAT, you will be able to add G700 Media Gateways
to the system.
At the SAT prompt, type add media-gateway <number>
1.
where <number> is the gateway number from 1 to 250.
The S8300 displays the Media Gateway screen.
Figure 76. Media Gateway Screen
Figure 77. Add Media Gateway Screen
Complete the Name field with the hostname assigned to the G700 Media Gateway.
2.
Complete the Identifier field with the serial number of the G700 Media Gateway. You can obtain
3.
the serial number by using the show system Media Gateway Processor CLI command at the
"super" prompt. See
154 for details.
!
CAUTION:
Be sure the serial number for the G700 Media Gateway you enter in this procedure matches
exactly the serial number displayed in
entered incorrectly, the serial number will prevent the S8700 Media Server from
communicating with the G700 Media Gateway. In this case, the phones won't work.
Complete the Network Region field with the value supplied in the planning documentation.
4.
Only if specifically requested by the customer or your planning documents, type gateway-
5.
announcements in the V9 field. This field allows you to enable announcements on the G700
Media Gateway. V9 is a virtual slot. There is no announcement board associated with it. The
announcements for the G700 are available in the G700 firmware and are administered in the same
way as announcements on the TN2301 circuit pack used on S8700 port networks.
If there are multiple G700 Media Gateways sharing announcements, then enable announcements
on the G700 that is connected to the trunks that will receive the announcements most often.
176
"Check the Serial Number of the G700 Media Gateway Processor" on page
"Get the Serial Number of the G700" on page
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002
145. If