Avaya G700 Installation And Upgrades page 155

4 Configuring a New G700 with an S8700 (No Local Survivable Processor):
Figure 68. Show System List for G700 Media Gateway
Write the serial number on your planning document. Make sure it matches the serial number
3.
sticker on the back of the G700 Media Gateway chassis. If there is a difference, the serial number
on the list of attributes in
Assign the IP Address to the G700 Media Gateway Processor
Begin
If, after you have assigned an IP address to the G700 processor, you telnet directly to the G700
Media Gateway processor, you will need to login, and the login name and password will be
provided in the planning documentation.
At the MG-???-n(super)# prompt, type configure to reach the configuration level of the
1.
command line interface.
Type nvram init to recondition the processor.
2.
The system prompts you to verify that you want to erase the configuration.
Answer the prompt by typing y(es).
3.
This procedure reinitializes the G700 software back to factory defaults so new IP addresses can be
stored correctly in the software. It also clears all configuration and administration on the G700
Media Gateway.
The G700 Media Gateway reinitializes.
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002
MG-001-1(super)# show sys
Uptime(d,h:m:s): 1, 08:17:12
System Name : -- Empty --
System Location: -- Empty --
System Contact : -- Empty --
MAC Address : 00-04-0D-02-04-EF
Serial No : 02DR07428721
Model No : G700
HW Vintage : 00
HW Suffix : A
FW Vintage : 230
Media Gateway Power Supplies
VOLTAGE(V) ACTUAL(V)
---------- ---------- ----------
DSP Complex 3.4
MGP 5.1
Fans 1.2
Media Modules -48.0
VoIP DSP 1.6
VoIP 8260 2.5
Aux -48.0
--type q to quit or space key to continue--
MG-???-1(super)#
Figure 68
3.359
5.000
0.000
-47.259
1.570
2.470
0.000
is correct.You will need this later.
STATUS
OK
OK
OK
OK
OK
OK
OK
155