Avaya G700 Installation And Upgrades page 116

3 Configuring a New G700 with an S8300 (Primary Controller or Local Survivable Processor):
At the P330-1(configure)# prompt, type
2.
copy tftp SW_image<file> EW_archive <ew_file>
<tftp_server_address> <Module#>
where
<file> is the image file with format and vintage number similar to viisa3_8_2.exe,
<ew_file> is an embedded web application file with format similar to p330Tweb.3.8.6.exe,
<tftp_server_ip_address> is the ip address of the S8300, and
<Module#> is the number, 1 through 10, of the media gateway in the stack. If there is only one
G700 Media Gateway, the number is 1.
Verify that the download was successful when the prompt returns. Type show image
3.
version.
End
Install New Firmware on the G700 Media Gateway Processor
Begin
At the P330-1(configure)# prompt, type session mgp to reach the G700 Media Gateway
1.
processor.
Type configure at the MG-???-1(super)# prompt to enter configuration mode, which will
2.
change the prompt to MG-???-1(configure)#.
At the MG-???-1(configure)# prompt, type show mgp bootimage to determine which
3.
disk partition (bank) is Active Now. You will update the bank that is not listed as Active Now. For
example, if the G700 vintage listed when you performed
S8300" on page 82
At the MG-???-1(configure)# prompt, type
4.
copy tftp mgp-image <bank> <filename> <tftp_server_ip_address>
to transfer the mgp image from the tftp server to the G700, where
<bank> is the bank that is not Active Now.
<filename> will begin with mgp and will be similar to a name like mgp_230_0.bin.
<tftp_server_ip_address> is the ip address of the S8300. See the following example:
copy tftp mgp-image a mgp_230_0.bin 195.123.49.54.
The screen will show the progress.
5. Verify that the download was successful when the prompt returns.
Type show mg list_config.
116
showed A, you will upgrade B.
Installation and Upgrades for the G700 with an S8300/S8700
"Determine Necessary Upgrades to the
555-234-100 — Issue 2 — October 2002