Install The New License File, If Necessary - Avaya G700 Installation And Upgrades

5 Upgrading an Existing G700 with an S8300 (Primary Controller or Local Survivable Processor):
f . In the Exceptions box, type 192.11.13.6. If there are any existing entries in this box, add to
the list of entries and separate entries with a ";".
g . Click OK to close the Manual Proxy Configuration dialog box.
h . Click OK again to close the Preferences dialog box.

Install the New License File, If Necessary

You load new license or authentication files from the services laptop or another computer on the network.
Note: If your S8300 Media Server is already set up for remote access, Avaya services
personnel can copy new license and authentication file information directly into
the FTP directory on the server. Avaya personnel will notify you when the new
files are in place as agreed (for example, by telephone or email). To install the
files, use the Install License and Install Avaya Authentication screens from
the S8300 main menu web-page.
Note: Before an upload or download, be sure the S8300 FTP directory contains no files
with a .pwd or.lic extension. Only one of these files can exist in a directory. If one
exists, move, rename, or delete it.
!
CAUTION:
After you install new license and authentication files, be sure to perform
Translations (Only If New License or Authentication Files Installed)" on page
saves the official passwords for the customer's system in the MultiVantage Software. If you
fail to perform this step, you may be irretrievably locked out of the system later in the
installation when the system reboots.
Connect Laptop to Services Port of S8300
Begin
Note: If you are upgrading an S8300 LSP remotely, you do not physically connect your
laptop to the S8300.
To connect your laptop directly to the S8300 Media Server:
Make sure your laptop meets the hardware and software requirements.
1.
Plug an Ethernet crossover cable (MDI to MDI-X) into the 10/100 BaseT Ethernet network
2.
interface card (NIC) on your laptop.
- Crossover cables of various lengths are commercially available.
- See Table 11
shown) is required
Connect the other end of the laptop's Ethernet cable to the Services port on the front of the S8300
3.
media server (see
If your laptop is already configured with the correct network settings, you can now open your
4.
Internet browser and log in.
190
for pinout connections if needed. Crossover of the transmit and receive pairs (as
Figure 81 on page 185).
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002
"Run Save
196. This task