Assign The Ip Addresses Of The G700 Media Gateway Components - Avaya G700 Installation And Upgrades

3 Configuring a New G700 with an S8300 (Primary Controller or Local Survivable Processor):
12. Check the FW VINTAGE column for vintages of each of the installed Media Modules: MM710,
MM711, MM712, MM720, and/or MM760 to see if they match the FW vintages in the Release
Letter. If not, you must upgrade them, as well.
End
Assign the IP Addresses of the G700 Media
Gateway Components
You will now assign the IP address to the P330 Stack Processor (Layer 2 Switching Processor). This
address has been provided to you on the IP Addressing Planning Form. The command arguments you
will be supplying include:
inband
vlan
IP address
netmask
IP route
destination
nvram init
gateway
108
–the interface of the Avaya P330 Stack Processor that requires an
IP address
–Virtual Local Area Network: a defined network segment that
allows users on that segment to have priority services in sharing
information with each other.
If the network is not using VLANs, the VLAN should be 1.
Otherwise, use the VLAN numbers indicated in your planning
forms. The Avaya G700 Media Gateway should be assigned the
same VLAN as the VLAN to which the Ethernet ports are
connected. The Avaya P330 Stack Processor might or might not
be assigned to the customer's network management VLAN.
–the unique identifier assigned to an entity on the Internet
–the subnet mask for the customer's LAN segment
–specifies the gateway to use to access distant networks
–distant networks that the IP route command needs to send
packets to. Usually generalized to 0.0.0.0 for networks other than
the local segment.
–the P330/MGP CLI command that ensures configuration
information is cleared so you can enter the IP address and IP route
information.
–the gateway the ip route command specifies to get to the distant
networks
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002