Administer Multivantage Software On The S8300 (When Primary Controller Only) - Avaya G700 Installation And Upgrades

3 Configuring a New G700 with an S8300 (Primary Controller or Local Survivable Processor):
Configure Other G700 Media Gateways (Remote, No Stack Configuration)
Begin
If additional G700 Media Gateways are supported in the configuration, but they are not attached
as a stack, then you must configure each G700, with all of its devices, including the Avaya P330
device processors. Additionally, you must check firmware and update the firmware as required.
Repeat the steps in the sections,
1.
on the G700 Media Gateway"
End
Administer MultiVantage Software on the
S8300 (When Primary Controller Only)
!
CAUTION:
This administration applies only to an S8300 that serves as the primary controller, which can
be either an internal or an external S8300. If the S8300 is an LSP, do not administer
MultiVantage software on it. Translations are automatically copied to the S8300 LSP from
the S8700.
To continue administration of various features available to the S8300 Media Server with G700 Media
Gateways, you will use the SAT tools. Among many other tasks, you will use the SAT interface to:
• Provide Ethernet access to MultiVantage
• Define the IP Network Region
• Add a Media Gateway
Note: This document covers only the administration of MultiVantage software required
for the G700 Media Gateway to communicate with the primary controller over a
customer's network. For the majority of administration required, see
''Administrator's Guide to MultiVantage Software, 555-233-506,'' or
''Administration for Network Connectivity for MultiVantage Software, 555-233-
504.''
!
CAUTION:
Before continuing, be sure you have saved translations in MultiVantage software (see
Save Translations" on page
122
"Configure the G700 Media Gateway"
for other G700 Media Gateways in the stack.
82).
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002
and "Load New Firmware
"Run