Avaya G700 Installation And Upgrades page 141

3 Configuring a New G700 with an S8300 (Primary Controller or Local Survivable Processor):
2 . Type telnet 192.11.13.6 and press Enter.
3 . Log in as craft.
4 . At the prompt, type almcall -f INADS phone number -s second-number and press Enter.
5 . At the prompt, type almenable -d b -s y and press Enter.
6 . Type almenable and press Enter to verify that the alarms are enabled.
7 . Log off.
End
Configure an SNMP Community String for Traps
Begin
Configuring the Avaya™ G700 Media Gateway to send SNMP traps to the primary server can be
accomplished by two commands:
• Layer 2 Switching Processor CLI command set snmp community trap [community string]
• Media Gateway Processor (MGP) CLI command set snmp trap <IP address> enable
SNMP requires community strings to be used for each SNMP 'request'. You can set only three
community strings on the G700 — one each for read requests, write requests, and traps. The
command for traps is set snmp community trap [community string].
1. Open the Run dialog box.
Type telnet <IP address of L2 Processor> and press Enter.
2.
3. Log in as root.
At the L2 Processor CLI prompt, type set snmp community trap [community string] and press
4.
Enter.
Type exit
5.
End
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002
141