Avaya G700 Installation And Upgrades page 106

3 Configuring a New G700 with an S8300 (Primary Controller or Local Survivable Processor):
4. Type configure
The prompt appears as P330-1(configure)#.
End
Note:
To check the syntax of a command in the command line interface, type as much of the command
as you know followed by help. For example:
P330-1(configure)#> set help
you will be given the current list of set commands available. If you type:
P330-1(configure)#> set interface help
you will be given a much more restricted list of command possibilities that address the possible
interfaces to be set.
For a complete list of command line interface commands, refer to the "Avaya™ P330 ManagerUser's
Guide".
Determine Necessary Firmware to Install on the G700
Begin
The first steps determine if new firmware for the P330 Stack Processor (Layer 2 Switching Processor)
is necessary.
Login to the Avaya P330 command line interface.
1.
2. At the P330-1(super)# prompt, type configure
At the P330-1(configure)# prompt, type dir
3.
The list of software appears.
Figure 45. Directory List for P300 Processor
Check the version number of the EW_Archive file to see if it matches the Release Letter. If not,
4.
you must upgrade the P330 Stack Processor (Layer 2 Switching Processor).
106
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002
.
.