5
Connect Media Gateways
NOTE:
Complete this step only if you are connecting more than one G700 Media Gateway in a stack
configuration.
Quick Start: G700 Hardware Installation
November 2003
1
Using the gray X330SC short cables,
connect the media gateways from the
bottom up:
•
Connect the light gray connector to the port
labeled "Cable to upper unit."
•
Connect the dark gray connector to the port
labeled "Cable to lower unit."
•
Repeat both steps until all units in the stack
are connected (maximum of 10 units).
2
For single stack redundancy, connect the
bottom unit and the top unit using the black
X330RC redundancy cable:
•
Connect the light gray connector to the port
labeled "Cable to upper unit: on the top unit
of the stack.
•
Connect the dark gray connector to the port
labeled "Cable to lower unit" on the bottom
unit of the stack.
Connect Media Gateways
19