Avaya G700 Installation And Upgrades page 130

3 Configuring a New G700 with an S8300 (Primary Controller or Local Survivable Processor):
Assign the S8700's CLAN Node Name and IP Address
Begin
Note: This should have already been established as a part of normal S8700 installation.
Note: The CLAN boards must be TN799DP running version 5 or greater firmware. Be
sure to check the firmware version for these boards on the S8700. For
information on how to upgrade the firmware on the S8700, please see the section
"Upgrade Firmware in Selected Port Cabinet Packs" in Upgrading the Avaya
Media Server Configuration in the S8700 documentation portion of this
documentation CD, ''Avaya S8300 and S8700 Media Server Library CD, 555-
233-325.''
At the S8700 SAT prompt, type change node-names ip to open the Node Names screen.
1.
2. Go to page 2
Figure 57. Node Names Screen.
change node-names ip
of 2
Name
default_________
node-1
node-2___
node-4__________
__________
3. Enter the appropriate values for the Media Gateway (node-4 in this example).
Field
Name
IP
Address
4. Press F 3 (
End
130
IP Address
0__.0__.0__.0__
__ 192.168.1 _.124
192.168.1 _.97
192.168.1 _.51_
. . _.
The node names for the following two nodes were already on the
screen:
• node-1: C-LAN Ethernet port on the S8700 switch.
• node-2: Interface on the router to the subnet of the S8700
switch.
The unique IP address for the C-LAN node named in the previous
field. See the description of the Subnet Mask field in the next task
for information on valid IP addresses.
E NT ER ) when complete.
Installation and Upgrades for the G700 with an S8300/S8700
NODE NAMES
Name
_______________
_______________
_______________
_______________
_ _______________
Conditions/Comments
555-234-100 — Issue 2 — October 2002
Page 2
IP Address
___.___.___.___
___.___.___.___
___.___.___.___
___.___.___.___
___.___.___.___