Avaya G700 Installation And Upgrades page 123

3 Configuring a New G700 with an S8300 (Primary Controller or Local Survivable Processor):
Reboot the System
Begin
1. Log in to the S8300 using telnet. You may already have a live telnet session available.
At the command prompt, type reset system 4
2.
The system reboots.
End
Log in to the MultiVantage SAT Screens
Begin
If you already have a valid telnet session in progress, access the SAT program by typing sat or
1.
dsat . Go to step 4.
If you are not yet logged in, open a telnet program on your computer. For example:
2.
- On a Windows system, go to the Start menu and select Run .
- To log in directly to the SAT program, type telnet <IP address> 5023
Log in to the MultiVantage software as craft .
3.
Enter your login confirmation information as prompted:
- Password prompt. Type your password in the Password field, and click Login or press Enter
again.
- ASG challenge. If the login is Access Security Gateway (ASG) protected, you will see a
challenge screen. Enter the correct response and click Login or press Enter.
Enter your terminal type. Accept the default value, or enter the appropriate type for your
4.
computer. For example, you may use type ntt, a terminal type available for Windows NT4.0 or
Windows 98. For Windows 2000, use w2ktt.
The SAT interface appears.
Enter SAT commands as appropriate.
5.
End
Define the IP Network Region for the G700 Media Gateway
Begin
You must define an IP network region according to the planning documentation. Use the system
defaults if the planning documentation does not specify otherwise.
For a G700 Media Gateway with an S8300 Media Server as primary controller, there will usually
be one network region, defined as 1. You normally define this network region on the S8300
MultiVantage software, using the system defaults. You then assign the network region to the G700
Media Gateway.
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002
123