Avaya G700 Installation And Upgrades page 154

4 Configuring a New G700 with an S8700 (No Local Survivable Processor):
Login at the Welcome to P330 menu.
4.
The prompt P330-1(super)# appears.
Type configure to obtain the P330-1(configure)# prompt.
5.
End
Establish the IP Routing for the Stack
Begin
Type show interface inband to verify that the Avaya P330 stack server has the correct
1.
address.
Type set ip route 0.0.0.0 <default-gateway> to set the destination and gateway
2.
IP addresses. You will find these addresses in the planning documentation. <default-
gateway-IP> is the IP address of the customer's network gateway.
Press Enter to save the destination and gateway IP addresses.
3.
4. Type show ip route
The route net and route host tables appear. Verify that the information is correct.
End
Check the Serial Number of the G700 Media Gateway Processor
Begin
After you have configured the Avaya P330 Stack Processor, you will assign an IP address to the
G700 Media Gateway Processor (MGP). Your first step is to check the serial number of the MGP.
At the P330-1(configure)# prompt, type session mgp.
1.
2. At the MG-???-1(super)# prompt, type show system to list various attributes of the
G700.
A list of attributes appears, as shown in the following example:
154
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002