Avaya G700 Installation And Upgrades page 120

3 Configuring a New G700 with an S8300 (Primary Controller or Local Survivable Processor):
Figure 51. Show Call Controller Status Screen
MG-001-1(configure)# show mgc
CALL CONTROLLER STATUS
------------------------------------------
Registered
Active Controller
H248 Link Status
H248 Link Error Code: 0x0
MGC List Management : Static
CONFIGURED MGC HOST
--------------------
135.9.71.95
- Not Available --
- Not Available --
- Not Available --
The Gateway will have registered with the S8300, if present. If the S8300 or S8700 is running and
has been administered properly, the Registered field says YES and the H248 Link Status says UP.
If the server is not running, the Registered field says NO and the H248 Link Status says DOWN.
End
Set the LSP Transition Points
Begin
You must set the time that the G700 searches, in the event of a network problem, for primary
controllers (for example, additional CLAN connections) with which to register. After this search
time has elapsed, the G700 will search for an LSP with which to register. You must also set the
total time the G700 searches for either a primary controller and an LSP, after which the G700
resets. And finally, you must define how many primary controllers, from 1 to 4, are in the
controller list you just defined.
At the MG-001-1(configure)# prompt, type set mgp reset-times primary-search
1.
<search-time>
where <search-time> is the time in minutes that the G700 searches for a primary controller
before looking for an LSP. The range is from 1 to 60.
120
: YES
: 135.9.71.95
: UP
DHCP SPECIFIED MGC HOST
-----------------------
-- Not Available --
-- Not Available --
-- Not Available --
-- Not Available --
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002