Avaya G700 Installation And Upgrades page 270

Appendix C: Equipment List:
Table 23. Equipment List: Media Modules Continued
Media Modules
Provides the ability to remotely troubleshoot the MM 710 T1/E1 Media Module. It
is required for any customer with a maintenance contract and highly
recommended for any other customer.
Material Code: 107988867
The MM711 Analog Media Module supports eight analog interfaces allowing the
connectivity of Loop Start, Ground Start, Analog DID trunks, and 2-wire analog
Outgoing CAMA E911 trunks. As well, the MM711 Analog Media Module allows
connectivity of analog, tip/ring devices such as single line telephones, modems
or group 3 fax machines. Each port may be configured as either a trunk interface
or a station interface.
Also included is support for caller ID signaling, ring voltage generation for a
variety of international frequencies and cadences and administrable line
termination styles.
Material Code: 170899
ComCode (for Services Ordering Only): 108919960
The MM712 DCP Media Module allows connectivity of up to 8 two-wire DCP
voice terminals. MM712 will not support 4-Wire DCP telephones.
Signal timing specifications for the MM712 support TDM Bus Timing in receive
and transmit modes. The G700 Media Gateway supplies only +5 VDC and –48
VDC to the MM712 Media Module. Any other required voltages must be derived
on the module.
Loop range secondary protection is provided on the MM712. The MM712 is also
self-protecting from an over current condition on a tip and ring interface.
Material Code: 170898
ComCode (for Services Ordering Only): 108919952
270
Apparatus Code: None
MM711 Analog Media Module
Apparatus Code: MM711
MM712 DCP Media Module
Apparatus Code: MM712
MM720 BRI Media Module
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002
Required for any customer
with a maintenance
contract and an MM710
T1/E1 Media Module,
highly recommend for
other customers to avoid
expensive technician
visits.
Optional
Optional
2 of 3