Avaya G700 Installation And Upgrades page 89

3 Configuring a New G700 with an S8300 (Primary Controller or Local Survivable Processor):
8. You can ping the S8300 continuously to see when the installation is complete. To ping the S8300,
do the following:
a . Open a DOS window.
b . At the command prompt, type ping -t 192.11.13.6.
The ping will succeed only when the reboot is complete.
Alternatively, you can wait three minutes or more and press the Refresh button to see if the reboot
is complete. Monitor the LEDs on the S8300 for progress on the installation. The Services port
jack should have one yellow LED on the left that stays lit. The green LED on the right flashes
until the reboot is complete.
When the pinging of the S8300 is successful a dozen times, or pressing the Refresh button shows
9.
that the reboot is complete, click Continue.
The S8300 displays the Installation Complete screen.
Figure 30. Installation Complete Screen
Click Close.
10.
You will be returned to the main menu where you must make the upgrade permanent.
End
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002
89