Avaya G700 Installation And Upgrades page 166

4 Configuring a New G700 with an S8700 (No Local Survivable Processor):
4. Type
copy tftp mm-image v<slot #> <filename mm> <tftp_server_ip_address>
where <slot #> is the slot of the specific media module as identified when you performed
"Determine Necessary Firmware to Install on the G700" on page
media module software in a format such mm712v58.fdl, and <tftp_server_IP_address> is the ip
address of the laptop or customer PC.
Two or three minutes will be required for most upgrades. The VoIP Media Module upgrade takes
approximately 5 minutes. Screen messages indicate when the transfer is complete.
At the MG-???-1(configure)# prompt, type show mg list_config
5.
The list of software appears.
Refer to the output of
6.
v4), then check the matching field in the FW VINTAGE column to see if it matches the Release
Letter.
7. Refer again to the output of
number matches the VoIP firmware identified in the Release Letter.
End
Set SNMP Traps
Begin
Set SNMP traps on the G700 Media Gateway so that the S8700 MultiVantage Maintenance
software can detect problems with the G700 Media Gateway's network traffic.
- At the MG-???-1(configure)# prompt, type set snmp trap
<primary_controller_IP_address>
where <primary_controller_IP_address> is the IP address of the S8700 Media Server.
166
step 5. In the TYPE column, find the particular media module (v2 through
step 5. Check the VOIP FW column and row for slot v0 to see if the
Installation and Upgrades for the G700 with an S8300/S8700
151, <filename mm> is the
555-234-100 — Issue 2 — October 2002