Avaya G700 Quick Start Manual
Hardware installation
Hide thumbs
Also See for G700:
- Installing and upgrading (808 pages) ,
- Installing manual (768 pages) ,
- Installation and upgrades (734 pages)
Related Manuals for Avaya G700
Summary of Contents for Avaya G700
- Page 1 Quick Start Avaya G700 Media Gateway Hardware Installation 555-233-150 Issue 3 November 2003...
- Page 2 The final responsibility for securing both this system and its networked equipment rests with you - Avaya’s customer system Avaya Inc. provides a limited warranty on this product. Refer to your administrator, your telecommunications peers, and your managers. sales agreement to establish the terms of the limited warranty. In Base the fulfillment of your responsibility on acquired knowledge and addition, Avaya’s standard warranty language as well as information...
- Page 3 The LASER devices operate within the following parameters: Avaya attests that this registered equipment is capable of providing users access to interstate providers of operator services through the use • Maximum power output: -5 dBm to -8 dBm of access codes. Modification of this equipment by call aggregators to •...
- Page 4 FIC Code SOC/REN/ Network (SDoC) Identifier A.S. Code Jacks Avaya Inc. in the United States of America hereby certifies that the Ground Start CO trunk 02GS2 1.0A RJ11C equipment described in this document and bearing a TIA TSB-168 DID trunk 02RV2-T AS.0...
-
Page 5: Table Of Contents
Install Octaplane Stacking Module Connect Media Gateways Install S8300 Media Server Install Media and Expansion Modules Install Modem Connect the USB CD-ROM Drive 10 Install UPS 11 Apply Power 12 Connect the Laptop Quick Start: G700 Hardware Installation November 2003... - Page 6 Contents Quick Start: G700 Hardware Installation November 2003...
-
Page 7: Get License File, Software, And Firmware
Get License File, Software, and Firmware Get License File, Software, and Firmware The following tasks must be completed before you can install an Avaya S8300 Media Server with an Avaya G700 Media Gateway: • Meet with the customer to complete the Electronic Pre-installation Worksheet. The Electronic Pre-installation Worksheet contains specific information about the customer’s network... - Page 8 Get License File, Software, and Firmware Once you have verified that all activities are completed, you can begin product hardware installation following instructions in this guide — Quick Start Avaya G700 Media Gateway Hardware Installation. NOTE: The laptop PC that you use to launch the Avaya Installation Wizard must meet the following requirements: •...
-
Page 9: Conduct Equipment Inventory
Conduct Equipment Inventory The following list of equipment contains items that may not be needed for your configuration — those items will not be included in your inventory. Avaya G700 Media Gateway Chassis ALM PWR CPU MSTR LNK COL Tx... - Page 10 Expansion Module X330T16 X330STK Octaplane Stacking Module Avaya IA770 Messaging Module Modem USB CD-ROM Drive Uninterruptable Power Supply (UPS) for AC- Powered Gateways Only. NOTE: A stand-alone version of the UPS is shown. Quick Start: G700 Hardware Installation November 2003...
- Page 11 X330SC Short Cable NOTE: The X3300SC Short Cable is sometimes shipped attached to the X3300STK Octaplane Stacking Module. X3300RC Redundancy Cable Quick Start: G700 Hardware Installation November 2003...
- Page 12 Conduct Equipment Inventory X3300 LC Long Cable USB Cable and Adapter Crossover Ethernet Cable (CAT5) Serial or "Console" Cable and Adapter Groundwire Quick Start: G700 Hardware Installation November 2003...
- Page 13 Conduct Equipment Inventory AC Power Cord DC Power Cord (available first-Quarter 2004) Feet (used for table mounting) Quick Start: G700 Hardware Installation November 2003...
- Page 14 Conduct Equipment Inventory Quick Start: G700 Hardware Installation November 2003...
-
Page 15: Mount Media Gateway
The gateway can also be mounted in the rack using the screw holes in the middle of the chassis. DANGER: The weight of the media gateway is unevenly distributed and may require two persons to mount in the rack. Quick Start: G700 Hardware Installation November 2003... - Page 16 Connect the ground wire to the ground conductor on the back of the media gateway. Attach the other end of the ground wire to an approved ground. AC/DC version of the G700 chassis. (available first-Quarter 2004) Quick Start: G700 Hardware Installation November 2003...
-
Page 17: Install Octaplane Stacking Module
Install Octaplane Stacking Module Install Octaplane Stacking Module NOTE: Complete this step only if you are connecting more than one G700 Media Gateway in a stack configuration. From the back of the media gateway, remove the blank faceplate from the media module slot. - Page 18 Install Octaplane Stacking Module Quick Start: G700 Hardware Installation November 2003...
-
Page 19: Connect Media Gateways
Connect Media Gateways Connect Media Gateways NOTE: Complete this step only if you are connecting more than one G700 Media Gateway in a stack configuration. Using the gray X330SC short cables, connect the media gateways from the bottom up: •... - Page 20 “Cable to upper unit” on the top unit of the stack 1. • Connect the dark gray connector of the gray X330LC long cable to the port labeled “Cable to lower unit” on the bottom unit of the stack 2. Quick Start: G700 Hardware Installation November 2003...
-
Page 21: Install S8300 Media Server
Complete this step if you are installing an S8300 Media Server (configured as the primary controller or as a Local Survivable Processor). From the front of the G700 Media Gateway, remove the blank faceplate from slot V1. Remove the LED module and place in an anti- static bag. - Page 22 Tighten the captive screws on the S8300. ALM PWR CPU MSTR LNK COL Tx FDX FC Hspd LAG EXT1 EXT2 SHUT DOWN OK TO REMOVE SERVICES USB1 USB2 EXT1 EXT2 Quick Start: G700 Hardware Installation November 2003...
-
Page 23: Install Media And Expansion Modules
S8300 is installed, four media modules can be installed, with one media module using the upper left Slot 1. For installation of the media module(s), from the front of the G700 Media Gateway remove the upper right blank faceplate. Align each media module with the interior guides and insert into slot until firmly seated. - Page 24 Install Media and Expansion Modules Optional. For installation of the expansion module, from the front of the G700 Media Gateway remove the lower left blank faceplate. Align the expansion module with the interior guides and insert into slot until firmly seated.
-
Page 25: Install Modem
USB cable to either USB port. Following the instructions packaged with the modem, connect the other end of the USB cable to the modem. Connect the analog telephone line to the RJ- 11 jack on the modem. Quick Start: G700 Hardware Installation November 2003... - Page 26 Install Modem Quick Start: G700 Hardware Installation November 2003...
-
Page 27: Connect The Usb Cd-Rom Drive
Connect the USB CD-ROM Drive Plug the USB cable into either of the two USB ports on the faceplate of the S8300. Connect the other end of the USB cable to the CD-ROM drive. Quick Start: G700 Hardware Installation November 2003... - Page 28 Connect the USB CD-ROM Drive Quick Start: G700 Hardware Installation November 2003...
-
Page 29: Install Ups
Install UPS Install UPS Optional. For AC-powered gateways only. From the back of the G700 Media Gateway, connect the Uninterruptable Power Supply (UPS) using the manufacturer’s instructions. NOTE: A stand-alone version of the UPS is shown. Quick Start: G700 Hardware Installation... - Page 30 Install UPS Quick Start: G700 Hardware Installation November 2003...
-
Page 31: Apply Power
Apply Power Apply Power Apply power to each media gateway by connecting the power cord. NOTE: There is no on/off switch. The units will power up when connected. Quick Start: G700 Hardware Installation November 2003... - Page 32 Apply Power Quick Start: G700 Hardware Installation November 2003...
-
Page 33: Connect The Laptop
Subnet Mask: 255.255.255.252 Domain Name Service (DNS): disabled. Open MS Internet Explorer and disable the Proxy Server. In the browser address field, initiate access to the S8300 by typing in lower case: http://192.11.13.6 Quick Start: G700 Hardware Installation November 2003... - Page 34 If you are using the Avaya Installation Wizard, click on Launch Avaya Installation Wizard and continue. If you are not using the Avaya Installation Wizard, refer to the document, Avaya™ G700 Media Gateway Controlled by an Avaya S8300 or S8700 Media Server, 555-234-100, for additional instructions.