Avaya G700 Installation And Upgrades page 167

4 Configuring a New G700 with an S8700 (No Local Survivable Processor):
Set up the Controller List for the G700 Media Gateway
Begin
To complete the configuration of the G700 Media Gateway, you will establish a list of controllers.
This list begins with the IP address of the primary controller. In the event that the G700 Media
Gateway loses contact with its primary controller, it will seek to register with the other controllers
on this list.
Up to four IP addresses separated by commas can be entered to form the controller list.
Note: After you set up a controller list for the G700 Media Gateway, the G700 will reset
every 30 minutes in order to contact the controller. This is normal operation, and
does not indicate a problem.
At the MG-???-n(configure)# prompt, type set mgc list
1.
<ip_address>,<ip_address>,<ip_address>
where the first and second ip_addresses are for the first and second CLAN boards on the S8700,
and the third address is for the S8300 configured as an LSP.
Type reset mgp at the MG-???-n(configure)# prompt to reset the G700 Media Gateway
2.
processor.
A system prompt asks to confirm the reset.
Select Yes at the dialog box that asks if you want to continue.
3.
The G700 Media Gateway processor will reset. The LEDs on the G700 Media Gateway and the
Media Modules will flash. These elements will each conduct a series of self-tests. When the LEDs
on the Media Modules are extinguished and the active status LEDs on the G700 Media Gateway
are on, the reset is complete.
At the P330-1(configure)# prompt, type session mgp.
4.
At the MG-001-1(super)# prompt, type configure to reach the configuration level of the
5.
command line interface.
Note: Because the G700 media gateway has registered with its primary controller, the
prompt name has changed to MG-001-1.
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002
167