Avaya G700 Installation And Upgrades page 127

3 Configuring a New G700 with an S8300 (Primary Controller or Local Survivable Processor):
If specifically requested by the customer or your planning documents, type gateway-
5.
announcements in the V9 field. This field allows you to enable announcements on the G700
Media Gateway. V9 is a virtual slot. There is no announcement board associated with it. The
announcements for the G700 are available in the G700 firmware and are administered in the same
way as announcements on the TN2301 circuit pack used on S8700 port networks.
If there are multiple G700 Media Gateways sharing announcements, then enable announcements
on the G700 whose trunks will receive the announcements most often.
Press F3 (
6.
Note: The IP Address, MAC Address, and Module Type fields are populated
automatically after the G700 Media Gateway registers with the server.
Figure 55. Media Gateway Screen (After Registration with S8700)
The Media Modules installed in the G700 are listed next to their slot numbers.
End
Verify Changes
Begin
To verify that a G700 Media Gateway has been successfully added:
1. At the SAT prompt, type list media-gateway.
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002
) to save your changes.
E NTE R
127