Avaya G700 Installation And Upgrades page 138

3 Configuring a New G700 with an S8300 (Primary Controller or Local Survivable Processor):
2. Verify that the G700 Media Gateway has registered.
The y in the registered field signifies that the G700 Media Gateway has registered. If the G700
should become unregistered, the y will become an n, but the IP address will remain assigned to
the G700 Media Gateway. If the G700 has never been registered, the IP Address field will be
blank.
If the G700 fails to register, two common causes might be:
- The serial number added as the identifier for the G700 is wrong. To check, log back into the
G700 gateway and type show system. Check the serial number that appears.
- There is no IP connection between the G700 and the S8300. To check, type show mgc and
then ping mgp <controller_address>.
End
Enable Announcements, If Necessary
Begin
Only if specifically requested by the customer or your planning documents, at the SAT prompt,
1.
type enable announcement-board <gateway_number>V9, where
<gateway_number> is the number of the G700 Media Gateway you just added and V9 is the
virtual slot (for example, 2V9 means Media Gateway number 2, slot V9.
Press
2. E NT ER
The system displays the message Command successfully completed.
End
Save MultiVantage Translations
Begin
- At the SAT prompt, type save translations.
End
138
to enable announcements.
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002