Avaya G700 Installation And Upgrades page 187

5 Upgrading an Existing G700 with an S8300 (Primary Controller or Local Survivable Processor):
Select Internet Protocol (TCP/IP)
5.
Click the Properties button. The Internet Protocol (TCP/IP) Properties screen appears.
6.
On the General tab, select the radio button Use the following IP address . Enter the following:
7.
- IP address: 192.11.13.5
- Subnet mask: 255.255.255.252
Note:
Disable DNS service as follows:
8.
a . Click the radio button labeled Use the following DNS server addresses . The entries
for Preferred DNS server and Alternate DNS server should both be blank.
b . Click the Advanced button at the bottom of the screen. The Advanced TCP/IP Settings
screen appears.
c . Click the DNS tab. Verify that no DNS server is administered (the address field should be
blank).
9. Disable WINS Resolution as follows:
a . Click the WINS tab. Make sure WINS is not administered (the address field should be
blank).
b . Click OK . If warned about an empty primary WINS address, click Yes to continue.
Click OK twice to accept the address information and close the TCP/IP and Local Area
10.
Connection Properties dialog boxes.
Reboot the system if directed to do so.
11.
After you have made these changes to your computer's network configuration information, the
Network and Dial-up Connections window shows the status of the Local Area Connection:
- Enabled appears when the laptop's Ethernet cable is connected to the server.
- Disabled or unplugged appears if the NIC is not connected to anything.
Change TCP/IP properties (Windows 95, 98, NT 4.0, and Millennium Edition [ME])
Begin
1. Access your computer's network information. On your desktop:
- Windows 95, 98, and NT: Right-click Network Neighborhood.
- Windows Me: Right-click My Network Places.
Select Properties to display the Network dialog box.
2.
Locate the TCP/IP properties as follows:
3.
- Windows 95, 98, and Me: On the Configuration tab, scroll through the installed network
components list to the TCP/IP part of the devices list. Select the TCP/IP device that
corresponds to your Ethernet card.
- Windows NT: On the Protocols tab, select TCP/IP in the installed network components list.
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002
Record any IP addresses, DNS settings, or WINS entries that you change.
You may need to restore them later to connect to another network.
187