Install an E1/T1 card and daughterboards
6. Connect the power cable.
7. Turn on the power.
Connect the RS-232 cable
This connection is used for the initial setup of basic LAN parameters by CLI. After initial setup,
all configuration, administration and maintenance are done through the Web interface. See
Connecting the RS-232 cable
Connecting the RS-232 cable
1. Connect the RS-232 serial port (D-type 9 pins) to a terminal or a PC with terminal
2. Configure the RS-232 serial port interface as follows:
62
Media Gateway 1000E PRI Gateway Installation and Commissioning
on page 62.
emulation (for example, HyperTerminal).
Important:
To connect the RS-232 cable, you require a null modem adapter.
• 9600 baud
• 8 data bits
• 1 stop bit
• No parity
• Flow control is "none"
Comments? infodev@avaya.com
March 2013