Avaya G700 Installation And Upgrades page 110

3 Configuring a New G700 with an S8300 (Primary Controller or Local Survivable Processor):
Figure 48. Show System List for G700 Media Gateway
MG-001-1(super)# show sys
Uptime(d,h:m:s): 1, 08:17:12
System Name
System Location: -- Empty --
System Contact : -- Empty --
MAC Address
Serial No
Model No
HW Vintage
HW Suffix
FW Vintage
Media Gateway Power Supplies
DSP Complex
MGP
Fans
Media Modules
VoIP DSP
VoIP 8260
Aux
--type q to quit or space key to continue--
MG-???-1(super)#
Write the serial number on your planning document. Make sure it matches the serial number
3.
sticker on the back of the G700 Media Gateway chassis. If there is a difference, the serial number
on the list of attributes in
End
Assign the IP Address to the G700 Media Gateway Processor
Begin
If, after you have assigned an IP address to the G700 processor, you telnet directly to the G700
Media Gateway processor, you will need to login, and the login name and password will be
provided in the planning documentation.
At the MG-???-n(super)# prompt, type configure to reach the configuration level of the
1.
command line interface.
2. Type nvram init to recondition the processor.
The system prompts you to verify that you want to erase the configuration.
110
: -- Empty --
: 00-04-0D-02-04-EF
: 02DR07428721
: G700
: 00
: A
: 230
VOLTAGE(V) ACTUAL(V)
---------- ---------- ----------
3.4 3.359
5.1 5.000
1.2 0.000
-48.0 -47.259
1.6 1.570
2.5 2.470
-48.0 0.000
Figure 48 is correct.You will need this later.
Installation and Upgrades for the G700 with an S8300/S8700
STATUS
OK
OK
OK
OK
OK
OK
OK
555-234-100 — Issue 2 — October 2002