Avaya G700 Installation And Upgrades page 30

1 Getting Started:
Table 3. Task List to Install a New G700 (with an S8300 or Local Survivable
Processor) Continued
Task
"Configure an X330 Expansion Mod-
ule (If Necessary)" on page 113
"Check for IP Connections" on page
113
"Load New Firmware on the G700
Media Gateway" on page 114
"Administer MultiVantage Software
on the S8300 (When Primary Con-
troller Only)" on page 122
30
Subtasks (If any)
"Establish the IP Routing for the Stack" on page 109
"Check the Serial Number of the G700 Media Gateway
Processor" on page 109
"Assign the IP Address to the G700 Media Gateway
Processor" on page 110
"Assign the Default IP Route to the G700 Media Gate-
way" on page 112
"Assign IP Addresses to the VoIP Resources" on page
112
"Verify That the S8300 tftpboot Directory Has the Right
Firmware Versions" on page 115
"Install New Firmware on the P330 Stack Processor
(Layer 2 Switching Processor)" on page 115
"Install New Firmware on the G700 Media Gateway Pro-
cessor" on page 116
"Install New Firmware on the Media Modules" on page
117
"Set SNMP Traps" on page 118
"Set up the Controller List for the G700 Media Gateway"
on page 118
"Set the LSP Transition Points" on page 120
"Configure Other G700 Media Gateways (Stack Config-
uration)" on page 121
"Configure Other G700 Media Gateways (Remote, No
Stack Configuration)" on page 122
"Reboot the System" on page 123
"Log in to the MultiVantage SAT Screens" on page 123
"Define the IP Network Region for the G700 Media
Gateway" on page 123
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002
Installation Roadmap and Task Lists
4 of 6