Avaya G700 Installation And Upgrades page 102

3 Configuring a New G700 with an S8300 (Primary Controller or Local Survivable Processor):
25. Check or change the items in question.
Click the Continue button to move forward again, whether you change anything or not. If you
26.
don't do this, information in the wizard may not be processed correctly.
Note: For any configuration, it is always safe to Cancel the configuration, and run the
Configure Server wizard again later from the beginning. You might use this option
if you are checking or modifying settings on a server that has already been
configured, and there is not a huge amount of new information to enter.
If you are satisfied that everything is set correctly, click Continue.
27.
If the configuration status stops at some point and the screen appears to freeze, you may have lost
contact with the server.
You can watch the progress of the configuration at the Updating System Files screen.
Figure 44. Updating System Files Screen
When the process is complete, you will receive a notification. Click Close Window and continue
the configuration of the G700 Media Gateway on the command line interface.
End
You have now configured the Avaya S8300 Media Server. If this is a new installation, you may also
have to load new software.
Note: You will also have to setup the INADS alarm via a command line. Call your
service support center.
102
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002