Avaya G700 Installation And Upgrades page 109

3 Configuring a New G700 with an S8300 (Primary Controller or Local Survivable Processor):
Assign the IP Address to the P330 Stack Processor (Layer 2 Switching Processor)
Begin
Type set interface inband <vlan> <ip_address> <netmask> at the P330-
1.
1(configure)# prompt. <vlan> is the vlan, usually 1, to be established on the S8300 for the
G700 Media Gateways. The <ip_address> <netmask> are the assigned addresses for the
P330 Stack Processor (Layer 2 Switching Processor).
Type reset and press Enter to reset the stack.
2.
Select Yes at the dialog box that asks if you want to continue.
3.
All LEDs will flash. As the unit powers up, self-tests will be run. When the G700 Media Gateway
or P330 Stack Processor (Layer 2 Switching Processor) has reset, login again to continue.
Login at the Welcome to P330 menu.
4.
The prompt P330-1(super)# appears.
Type configure to obtain the P330-1(configure)# prompt.
5.
End
Establish the IP Routing for the Stack
Begin
Type show interface inband to verify that the Avaya P330 stack server (Layer 2
1.
Switching Processor) has the correct address.
2. Type set ip route 0.0.0.0 <default-gateway> to set the destination and gateway
IP addresses. You will find these addresses in the planning documentation. <default-
gateway-IP> is the IP address of the customer's network gateway.
Press Enter to save the destination and gateway IP addresses.
3.
Type show ip route
4.
The route net and route host tables appear. Verify that the information is correct.
End
Check the Serial Number of the G700 Media Gateway Processor
Begin
After you have configured the Avaya P330 Stack Processor (Layer 2 Switching Processor), you
will assign an IP address to the G700 Media Gateway Processor (MGP). Your first step is to check
the serial number of the MGP.
At the P330-1(configure)# prompt, type session mgp.
1.
At the MG-???-1(super)# prompt, type show system to list various attributes of the
2.
G700.
A list of attributes appears, as shown in the following example:
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002
109