Avaya G700 Installation And Upgrades page 136

3 Configuring a New G700 with an S8300 (Primary Controller or Local Survivable Processor):
Figure 61. Media Gateway Screen
Complete the Name field with the hostname assigned to the G700 Media Gateway.
2.
Complete the Identifier field with the serial number of the G700 Media Gateway. You can obtain
3.
the serial number by using the show system Media Gateway Processor CLI command at the
"super" prompt. See
109. for details.
Complete the Network Region field with the value supplied in the planning documentation.
4.
If specifically requested by the customer or your planning documents, type gateway-
5.
announcements in the V9 field. This field allows you to enable announcements on the G700
Media Gateway. V9 is a virtual slot. There is no announcement board associated with it. The
announcements for the G700 are available in the G700 firmware and are administered in the same
way as announcements on the TN2301 circuit pack used on S8700 port networks.
If there are multiple G700 Media Gateways sharing announcements, then enable announcements
on the G700 that is connected to the trunks that will receive the announcements most often.
Press (
6. F 3
Note: The IP Address, MAC Address, and Module Type fields are populated
automatically after the G700 media gateway registers with the server.
136
"Check the Serial Number of the G700 Media Gateway Processor" on page
) to save your changes.
E NT ER
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002