Avaya G700 Installation And Upgrades page 107

3 Configuring a New G700 with an S8300 (Primary Controller or Local Survivable Processor):
5. At the P330-1(configure)# prompt, type show image version
The list of software appears.
Figure 46. Show Image Version List for P330 Processor
P330-1(configure)# show image version 3
Mod Module-Type
------ -----------
3 Avaya G700 Media Gateway
3 Avaya G700 Media Gateway
Check the version number of the stack software image file to see if it matches the Release Letter.
6.
If not, you must upgrade the P330 Stack Processor (Layer 2 Switching Processor).
The next steps determine if new firmware is required for the G700 Media Gateway Processor (MGP),
the VoIP Module, and the installed Media Modules.
7. At the P330-1(configure)# prompt, type session mgp
At the MG-???-1(super)# prompt, type configure
8.
9. At the MG-???-1(configure)# prompt, type show mg list_config
The list of software appears.
Figure 47. Configuration List for G700 Media Gateway
10. Refer to the output of
find G700, then check the matching field in the FW VINTAGE column to see if it matches the
Release Letter. If not, you must install new firmware on the G700 Media Gateway MGP. Also
check if the release number in the FW VINTAGE column contains an A or B to indicate the
software bank. If the list shows B, you will upgrade A. If the list shows A, you will upgrade B.
11. Refer to the VOIP FW column and row for slot v0 to see if the number matches the VoIP
firmware identified in the Release Letter. If not, you must also upgrade the G700 Media Gateway
motherboard VoIP module.
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002
step 9 to check the FW vintage number of the G700. In the TYPE column,
Bank Version
---- -------
A 0.0.0
B 3.8.2
107