INVT Goodrive300-19 Series Operation Manual page 74

Goodrive300-19 series open loop vector inverter special for hosit
Function
Name
code
Detailed instruction of parameters
FWD
K1
REV
K2
COM
1: 2-wire control 2; the enabling and the direction
separate. The defined FWD by this mode is the
enabling terminal. The direction depends on the state
of the defined REV.
FWD
K1
REV
K2
COM
2: 3-wire control 1; SIn is the enabling terminal on this
mode, and the running command is caused by FWD
and the direction is controlled by REV. Sin is
naturally closed.
SB1
FWD
SB2
SIn
REV
K
COM
3: 3-wire control 2; SIn is the enabling terminal on this
mode, and the running command is caused by SB1 or
SB3 and both of them control the running direction.
NC SB2 generates the stop command.
SB2
Note: For the 2-wire running mode, when FWD/REV
terminal is valid, the inverter stops because of the
Running
K1 K2
command
OFF OFF Stop
FWD
ON OFF
running
REV
OFF ON
running
ON ON Hold
Running
K1 K2
command
OFF OFF Stop
FWD
ON OFF
running
OFF ON
Hold
REV
ON ON
running
Running
K
command
FWD
ON
running
REV
OFF
running
SB1
FWD
SIn
REV
SB3
COM
-73-
Function parameters
Default
Modify
value