Disconnection From Supply Source; Removing / Mounting Removable Hard Disk - Keysight E5052B Installation Manual

Installation

Removing / Mounting Removable Hard Disk

Disconnection from Supply Source

The power supply of the E5052B is cut off by disconnecting the plug of the
power cable (on either AC outlet side or E5052B side). When it is necessary to
disconnect the power supply in order to avoid shock hazards, etc., pull out the
power cable plug from either the AC outlet side or the E5052B side.
To allow this operation to be performed smoothly, be sure to follow the
guidelines in
Immediate Disconnection of Power Cable in Case of Emergency" on
page
When turning the power OFF under normal circumstances, always follow
the methods described in
Removing / Mounting Removable Hard Disk
For details of removing / mounting removable hard disk, refer to the following
website
Keysight E5052B Signal Source Analyzer
"Ensuring Adequate Free Space around Analyzer for
15.
"Turning the Power OFF" on page
http://ena.support.keysight.com/e5052b/manuals/webhelp/eng/
24.
25