3.1.2
Selection of the measuring variants via softkeys (turning)
The following shows the measuring variants of the turning technology as a menu tree in the
program editor. All of the measuring variants available in the control are shown in the display.
However, on a specific system, only those steps can be selected that are possible for the set
extended technology.
Turning technology menu tree
The following softkeys are only displayed if the "Milling" extended technology is set (channel-
specific MD52201 $MCS_TECHNOLOGY_EXTENSION = 2).
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
→
→
→
→
→
Measuring variants
3.1 General requirements
Length (CYCLE973) (Page 214)
Radius on face (CYCLE973)
(Page 85)
Calibrate in slot (CYCLE973)
(Page 88)
Front edge (CYCLE974) (Page 92)
Inner diameter (CYCLE974, CY‐
CLE994) (Page 95)
Outer diameter (CYCLE974, CY‐
CLE994) (Page 99)
Calibrate probe (CYCLE982)
(Page 255)
Turning tool (CYCLE982)
(Page 261)
Drill (CYCLE982) (Page 272)
Length at edge (CYCLE976)
(Page 112)
Radius in ring (CYCLE976)
(Page 112)
Radius at edge (CYCLE976)
(Page 117)
Compare to sphere (CYCLE976)
(Page 124)
Inner diameter (CYCLE974, CY‐
CLE994) (Page 95)
75