Triumph Tiger Explorer XR 2017 Service Manual page 700

Tiger Explorer XR Series
Pinpoint Tests
Test
1 Has the battery been disconnected?
2 Check cable and terminal integrity:
- Battery terminals
- Chassis ECM pin A01
- Chassis ECM pin B01
- Alternator cable
3 Check fuse integrity
- Main fusebox, fuse 1 (PS1)
- Main fuse box, fuse 3 (PS3)
4 With Ignition 'ON', check Voltage at:
- Chassis ECM pin A01
- Chassis ECM pin B01
5 Reconnect harness, clear fault code
and run engine to verify fault cleared.
Circuit Diagram
Rear Preload Motor Maximum/Minimum End Stop Detection Error
Fault Code
C1130
696 of 746
Result
Yes
No
OK
Faulty
OK
Faulty
Same as 'across
battery' Voltage
Less than 'across
battery' Voltage
OK
Fault still present
Possible Cause
Chassis ECM parameters reset to
default
Action
Proceed to test 5
Disconnect Chassis ECM and proceed
to test 2
Proceed to test 3
Rectify fault, proceed to test 5
Proceed to test 4
Replace fuse(s), proceed to test 4
Proceed to test 5
Locate and rectify wiring fault, proceed
to test 5
Action complete - quit test
Contact Triumph service
Action
Download the latest chassis ECM
calibration to ensure correct
model specific configuration
ELECTRICAL