Triumph Tiger Explorer XR 2017 Service Manual page 74

Tiger Explorer XR Series
15. Reconnect the right hand coolant hose, refit the constant tension hose clamp.
Refill the cooling system (see Coolant Replacement).
Refit the throttle bodies (see Throttle Bodies/Injectors - Installation).
Refit the airbox (see Airbox - Installation).
Refit the fuel tank (see Fuel Tank - Installation).
Reconnect the battery positive, (red) lead first and tighten the terminals to 4.5 Nm.
Refit the rider's seat (see Rider's Seat - Installation).
Clutch Cover - Removal
Before starting work, ensure the motorcycle is stabilised and adequately supported. This will help prevent it
from falling and causing injury to the operator or damage to the motorcycle.
1. Remove the clutch slave cylinder (see Clutch Slave Cylinder - Removal). It is not necessary to drain the
clutch cylinder fluid. Retain the piston to the slave cylinder using a rubber band or cable tie.
Do not allow the clutch slave cylinder to hang on the clutch hose as this may damage the hose and could
impair clutch operation leading to loss of motorcycle control and an accident.
2. Tie the clutch slave cylinder aside.
3. Noting the position of the encapsulated fixing, remove the fixings and remove the clutch cover. Discard the
encapsulated fixing.
70 of 746
1
1. Electrical connectors
2. Ignition coils
WARNING
WARNING
2
2
ENGINE COVERS