Triumph Tiger Explorer XR 2017 Service Manual page 639

Tiger Explorer XR Series
the chassis ECM will automatically cut power to the affected system.
The chassis ECM can be reset by turning the Ignition off then on again. Power will be restored to the inoperative
system, providing that the condition that caused the fault has been rectified.
The systems controlled by the chassis ECM are also provided with a secondary level of protection, by fuses PS1
to PS5 in the main fuse box (see Fuse Identification). A blown fuse is likely when all of the systems protected by
that fuse become inoperative.
Refer to the following table for full details of the chassis ECM controlled systems, and their corresponding fuses.
Left headlight main beam
Left headlight dipped beam
Left front direction indicator
Left rear direction indicator
Rear position light
RSU position sensor (models with TSAS only)
Right headlight main beam
Right headlight dipped beam
Right front direction indicator
Right rear direction indicator
Front position light
Brake light
Windscreen adjustment motor
RSU pre-load adjustment motor (models with TSAS only)
RSU damping solenoid (models with TSAS only)
Front suspension compression damping adjuster (models with TSAS only)
Front suspension rebound damping adjustment motor (models with TSAS only)
Fog lights (if fitted)
USB connector
Heated seats (if fitted)
Heated grips (if fitted)
635 of 746
Electrical System Fuse
PS1
PS2
PS3
PS4
ELECTRICAL