Triumph Tiger Explorer XR 2017 Service Manual page 381

Tiger Explorer XR Series
Fork Oil Level
1. Fill the fork with the grade of oil specified in the fork oil table, to a level above that which will finally be
required.
Note
There are holes near the top of the fork inner tube to allow any oil between the fork inner and outer
tubes to go into the inner tube.
While pumping the fork assembly to expel any trapped air, keep the inner damper rod pressed down
into the main damper rod assembly using one finger.
2. Pump the fork and damper assembly several times to expel any trapped air then fully compress the fork and
support it in an upright position. Leave the fork for a few minutes to allow the oil to stabilise.
3. Raise the outer tube to the top of the inner tube and hold there for a couple of seconds then fully lower the
outer tube.
4. Set the scale on 3880160 -T0301 - Fork Oil Filler/Evacuator to 105 mm, as shown below.
377 of 746
Fork Oil Level (fork fully compressed with spring
guide, upper spring preload spacer(s) and spring
removed)
2
1
cirb_3
1. Main damper rod assembly
2. Inner damper rod
105 mm
FRONT SUSPENSION