Triumph Tiger Explorer XR 2017 Service Manual page 701

Tiger Explorer XR Series
Fault Code
Fault Code
C1131
C1132
C1133
C1134
Chassis Electronic Control Module (ECM) - Removal
Before starting work, ensure the motorcycle is stabilised and adequately supported. This will help prevent it
from falling and causing injury to the operator or damage to the motorcycle.
Remove the rider's seat (see Rider's Seat - Removal).
Disconnect the battery, negative (black) lead first.
1. Release the wing nut and remove the chassis ECM cover.
2. Disconnect the chassis ECM connectors (see Chassis ECM Connectors).
3. Remove the chassis ECM from the under seat tray.
697 of 746
Possible Cause
Possible Cause
Rear preload motor minimum end
stop detection error. Preload
motor not inhibited.
Rear preload motor minimum end
stop detection error. Preload
motor inhibited.
Rear preload motor Maximum end
stop detection error. Preload
motor not inhibited.
Rear preload motor Maximum end
stop detection error. Preload
motor inhibited.
WARNING
2
1. Wing nut
2. Chassis ECM cover
Action
Erase stored DTCs from all ECMs
Action
Rear preload motor calibration is
started automatically after next
ignition cycle
Allow rear preload motor to
calibrate, see Rear Suspension
Unit Preload Motor Calibration
1
ELECTRICAL