Triumph Tiger Explorer XR 2017 Service Manual page 185

Tiger Explorer XR Series
5. Fit the abutment sleeve between the ends of the abutment spring and install fully in to the transmission
casing.
6. Refit the washer to the outer end of the selector shaft.
7. Ensure that the two dowels are in position in the selector shaft cover.
8. Check the condition of the selector shaft seal; if necessary fit a new seal.
Take care to avoid damaging the lip of the seal when installing the selector shaft cover over the selector
shaft. A damaged seal will lead to oil loss and could result in engine damage.
9. Fit a new gasket to the selector shaft cover, and refit the cover.
10. Fit a new copper washer to the 90 mm selector shaft cover fixing.
11. Secure the cover with the three fixings, noting that the 90 mm fixing passes through the abutment sleeve.
181 of 746
2
chmu
1. Abutment sleeve
2. Washer
CAUTION
2
chfu
1. Selector shaft cover
2. Fixings
3. Copper washer position
1
1
2
3
TRANSMISSION