Triumph Tiger Explorer XR 2017 Service Manual page 590

Tiger Explorer XR Series
Fit the side fairings (see Side Fairings - Installation).
Reconnect the battery positive, (red) lead first and tighten the terminals to 4.5 Nm.
Refit the rider's seat (see Rider's Seat - Installation).
Seat Bridge - Installation
Before starting work, ensure the motorcycle is stabilised and adequately supported. This will help prevent it
from falling and causing injury to the operator or damage to the motorcycle.
Remove the rider's seat (see Rider's Seat - Removal).
Disconnect the battery, negative (black) lead first.
Remove the fuel tank (see Fuel Tank - Removal).
1. Detach the main fuse from the seat bridge.
2. Note the routing of the fuel drain hose and release it from its clips on the seat bridge.
The Inertial Measurement Unit (IMU) located beneath the seat bridge is a highly sensitive device. Exposure
to excessive shock and vibration can cause permanent damage to IMU internal components.
Care must be taken when removing or installing the seat bridge, not to expose the IMU to excessive shock or
vibration. When releasing or tightening the fixings, use suitable hand tools only. Do not use air or battery
powered tools.
When removed from the motorcycle, place the seat bridge and IMU assembly on a flat surface, in a location
that is isolated from shock and vibrations caused by other workshop processes.
Do not drop the IMU. An IMU that has been dropped will be irreparably damaged and must be replaced.
3. Disconnect the multiplug for the Inertial Measurement Unit (IMU).
4. Using a suitable hand tool, remove the four fixings and remove the seat bridge and IMU assembly from the
motorcycle.
586 of 746
chpv
1. Flanged sleeve
2. Fixing
3. Seat infill panel (left hand shown)
WARNING
CAUTION
4
3
cjjw
1
4
2
FRAME / BODYWORK