Triumph Tiger Explorer XR 2017 Service Manual page 328

Tiger Explorer XR Series
Disconnect the battery, negative (black) lead first.
Remove the coolant expansion tank (see Expansion Tank - Removal).
Remove the flywheel cover (see Flywheel Cover - Removal).
1. Remove and discard the two fixings securing the sensor to the crankcase.
2. Disconnect the sensor multiplug.
3. Detach the harness grommet from the opening in the crankcase.
4. Remove the crankshaft position sensor, detaching the harness from the crankcase retaining pegs as you do
so.
Crankshaft Position Sensor - Installation
Before starting work, ensure the motorcycle is stabilised and adequately supported. This will help prevent it
from falling and causing injury to the operator or damage to the motorcycle.
1. Refit the crankshaft position sensor. Fit and tighten new fixings to 6 Nm.
2. Reconnect the sensor multiplug.
3. Refit the harness grommet to the crankcase opening.
4. Refit the harness to the retaining pegs on the crankcase.
Refit the flywheel cover (see Flywheel Cover - Installation).
Refit the coolant expansion tank (see Expansion Tank - Installation).
Reconnect the battery positive, (red) lead first and tighten the terminals to 4.5 Nm.
Refit the rider's seat (see Rider's Seat - Installation).
Gear Position Sensor - Removal
Before starting work, ensure the motorcycle is stabilised and adequately supported. This will help prevent it
from falling and causing injury to the operator or damage to the motorcycle.
Remove the rider's seat (see Rider's Seat - Removal).
Disconnect the battery, negative (black) lead first.
324 of 746
chgh
1. Sensor
2. Fixings
WARNING
WARNING
2
1
2
FUEL SYSTEM / ENGINE MANAGEMENT